PicoScope 5443B Flexible Resolution USB Oscilloscope

Availability: In Stock / Short Lead Time
£1,595.00
  • Channels: 4 
  • Bandwidth: 100 MHz
  • Function Generator / AWG: AWG
Add to Wish List

PicoScope 5443B Flexible Resolution USB Oscilloscope

  • Channels: 4 
  • Bandwidth: 100 MHz
  • Function Generator / AWG: AWG
  • Buffer Size: 128 MS
  • Probes Supplied: 4 x 150 MHz

PicoScope 5000 Series Key Features:

  • Flexible Hardware Resolution, from 8 to 16 bits
  • 200 MHz analog bandwidth
  • 1 GS/s sampling at 8 bit resolution
  • 500 MS/s sampling at 12 bit resolution
  • 62.5 MS/s sampling at 16 bit resolution
  • 512 MS buffer memory
  • 100,000 waveforms per second
  • 200 MS/s Arbitrary Waveform Generator
  • Serial decoding and mask testing as standard
  • Windows, Linux and Mac software

Flexible Resolution

Most digital oscilloscopes gain their high sampling rates by interleaving multiple 8-bit ADCs. Despite careful design, the interleaving process introduces errors that always make the dynamic performance worse than the performance of the individual ADC cores.

The PicoScope 5000 Series scopes have a significantly different architecture in which multiple high-resolution ADCs can be applied to the input channels in different time-interleaved and parallel combinations to boost either the sampling rate to 1 GS/s at 8 bits or the resolution to 16 bits at 62.5 MS/s.

In time-interleaved mode, the ADCs are interleaved to provide 1 GS/s at 8 bits (see diagram). Interleaving reduces the performance of the ADCs, but the result (60 dB SFDR) is still much better than oscilloscopes that interleave 8-bit ADCs. This mode can also provide 500 MS/s at 12 bits resolution.

High dynamic range spectrum analysis

In parallel mode, multiple ADCs are sampled in phase on each channel to increase the resolution, revealing every detail of the signal in a crystal-clear display. Sampling in parallel with multiple ADCs and combining the output reduces noise and also both the integral and differential nonlinearity, providing outstanding single shot dynamic performance without loss of bandwidth or need of a repetitive signal

Using parallel mode, resolution is increased to 14 bits at 125 MS/s per channel (> 70 dB SFDR – see diagram). If only two channels are required then resolution can be increased to 15 bits, and in single-channel mode all the ADCs are combined to give a 16-bit mode at 62.5 MS/s.

The software gives the choice of selecting the resolution or leaving the scope in “auto resolution” mode where the optimal resolution is used for the chosen settings.