Fluke Calibration 710 mA Valve Testing Loop Calibrator
Fluke 710 mA Loop Valve Tester
24 V DC loop power with mA measure mode (-25 % to 125 %) Resolution of 1 μA on mA ranges and 1 mV on voltages ranges
The Fluke 710 Valve Testing Loop Calibrator is designed to enable users to perform quick, easy tests on HART smart control valves. Featuring built-in test procedures and an intuitive user interface, the 710 allows you to quickly and easily perform valve tests, while the valve test quick-check results provide at-a-glance diagnosis to help you make maintenance decisions faster than ever. The valve health test results let you know whether your valve is in good, marginal or in bad operating condition so you can quickly decide whether additional maintenance is necessary.
Key features
• Valve test procedures that deliver Good, Marginal or Bad assessment of a control valve
• Generic HART communication
• Best-in-class mA accuracy at 0.01 % measurement or source value
• Compact rugged design
• Intuitive user interface with Quick-Set knob for fast setup, easy to use
• 24 V DC loop power with mA measure mode (-25 % to 125 %)
• Resolution of 1 μA on mA ranges and 1 mV on voltages ranges
• Built in selectable 250 Ω resistor for HART communications
• Simple two wire connection for all measurements
• Auto shutdown to conserve battery life
• Variable step and ramp time in seconds.
KEY VALVE TESTING FUNCTIONS
Valve signature test, speed test, step test, manual test, bump/partial stroke test
KEY MA LOOP CALIBRATOR FUNCTIONS
mA source, mA simulate, mA read, mA read/loop power, and volts read
VALVETRACK™ SOFTWARE
Enables upload to a PC for further in-depth analysis of valve measurements that are logged and recorded to memory
-
• Gas and oil refining • Gas and oil midstream • Chemical processing • Pharmaceuticals • Water/Waste water • Food and beverage